Teledyne 6712SR - Manual (Page 147)

6712SR Refrigereated Sampler
Section 7 Remote Operation
7-7
7.1.3 Remote Control of
Sampler Keypad
To control the sampler keypad remotely, type CONTROL at the
“>” prompt and press ENTER. The sampler display is mirrored
on your computer monitor as you step through the programming
screens. While in this mode, the computer keys will be redirected
to simulate the sampler’s keypad, which will be disabled to avoid
any conflict. The active keys and their corresponding functions
are given in Table 7-3.
7.2 Telephone Commands 6712 controllers equipped with an internal voice modem can be
operated using telephone commands. This factory-installed
option includes a 12 ft (3.6 m) modem cable.
After connecting to the sampler from a touch-tone telephone,
command numbers may be entered from the telephone’s keypad,
followed by the
(pound) button. The commands are listed in
Table 7-4.
To use telephone commands:
1. Dial the sampler’s telephone number. When the sampler
connects, it answers with “Teledyne Isco Sampler Site
[number].” If the sampler does not receive a touch-tone
command in five seconds, it assumes that a computer
modem has called and initiates the modem connect
sequence. If this occurs you must hang up and try again.
2. Enter the command. For example, to run program 1, press
.
xxD_ 4, 5 Other data not listed above
1
The three most recent samples will have entries as B?. The “?” will be
the first bottle number in the set. If the sample is a grab sample, it will
be shown as B0.
2 Rainfall tips roll over every 256 counts.
3
The checksum does not include the checksum, carriage return, and
linefeed. The string is terminated with <CR><LF>.
4
A “_” in the identifier indicates an SDI-12 address.
5
“ XX ” matches the data label for the SDI-12 parameter.
Table 7-2 Serial Data Codes (Continued)
Identifier Parameter Units
Table 7-3 Remote Control of Sampler Keypad
Computer Sampler
<Esc>, S, s STOP
L,l,U,u, <Backspace> Left / Up
R, r, D, d Right / Down
O, o ON
<Enter>, arrows, decimal, numbers Same
You will not be able to turn the sampler off remotely.
#
1 #