VEGA VEGAMET 514… D - Manual (Page 23)

VEGAMET 514… D 23
Set-up, configuration
4.6.3 Configuration output
Dependent on the basic configuration the outputs are automatically coordinated to the measuring points
MST1 and MST2. This coordination can be modified separately for each output.
In a list either the measuring point numbers MST1 and MST2 or the previously adjusted measuring point
names are provided as choice. In addition each output can be switched off (--), i.e. the switched off output
does not access to any measuring point.
Configuration, outputs
Coordination acc. to basic configuration:
–– Configuration current outputs
–– Current 1 to
MST1
––– 0 … 20 mA level proportional
MST2
--
–– Current 2 to
MST2
––– 0 … 20 mA flow proportional
--
MST1
–– Kind 2
Standard
––
Pulses
–– Current 3 to
MST2
––– Flow pulses
--
MST1
–– Kind 3
Standard
Pulse
d ––
–– Configuration volt outputs
–– Volt 1 to
MST1
––– 0 … 10 V level proportional
MST2
--
–– Volt 2 to
MST2
––– 0 … 10 V flow proportional
--
MST1
–– Volt 3 to
--
––– not coordinated to a MST
MST1
MST2
>>