VEGA VEGAMET 391 4 … 20 mA_HART - Manual (Page 20)

20
6 Setup with the integrated display and adjustment unit
VEGAMET 391 • 4 … 20 mA/HART
36032-EN-130701
•
Further settings: Includes simulation, reset, PIN, sensor address,
…
•
Info: Shows serial number, software version, last change, instru-
ment features, MAC addr., …
→
Select the requested menu item via the respective keys and
confirm with [OK].
You can assign an unambiguous name to VEGAMET 391 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Carry out your settings via the appropriate keys and save with
[OK].
For instruments with integrated Ethernet interface, the automatic
addressing via DHCP is preset, i.e. the IP address must be assigned
by a DHCP server. Generally the instrument is contacted via the Host
name. By default, the host name consists of the serial number plus
"VEGA-" in front. As an alternative, it is also possible to enter a static
IP addr. with Subnet mask and optional Gateway addr.
Note:
Keep in mind that your modification will be only effective after a restart
of VEGAMET 391. You can find further information of these network
parameters in the supplementary instructions "RS232/Ethernet con-
nection" and in the Online help of the respective DTM.
1. Carry out your settings via the appropriate keys and save with
[OK].
2. Carry out your settings via the appropriate keys and save with
[OK]. Disconnect briefly the operating voltage so that the modi-
fied settings become effective.
For instruments with integrated RS232 interface, you determine here
which mode this serial interface should operate in. The following op-
tions are available:
Device settings - Device-
TAG
Device settings - Host
Name/IP addr.
Device settings - Commu-
nication protocol