GE Industrial Solutions Galaxy Vector Rack Mounted Controller J85501M-1 - Manual (Page 6)

Galaxy Rack-Mounted Vector Controller J85501M-1
2 - Table of Contents Issue 2 January 2008
3 Operation
Office Alarm Contacts 3 - 1
Alarm Descriptions 3 - 1
Very Low Voltage Alarms and Battery on Discharge 3 - 1
System Features 3 - 8
Battery Recharge Current limit 3 - 13
Battery Discharge Test 3 - 13
Plant Battery/Generator Test (PBT) 3 - 16
Remote Access and Monitoring 3 - 16
Remote Rectifier Standby 3 - 17
Dial-out On Alarm 3 - 17
4 Installation and Configuration
Wiring 4 - 1
Front Panel Operation 4 - 3
View Active Alarms Mode 4 - 4
Configuration 4 - 4
Battery Discharge Test Results 4 - 9
Battery Discharge Test Enable 4 - 10
Shunt Type/Size 4 - 10
Shunt Size 4 - 11
System Float Mode Settings 4 - 11
Very Low Voltage Threshold 4 - 12
Battery Recharge Current Limit Settings 4 - 12
Battery Thermal Compensation Settings 4 - 12
Low Voltage Disconnect Contactor 1 and 2 Settings 4 - 14
Plant Boost Mode Settings 4 - 14
Converter Settings 4 - 15
Voltage Calibration 4 - 16
Reserve Operation Engine 4 - 16
Serial Bus Updating and Clearing 4 - 16
Software Release Information 4 - 17
5 Troubleshooting
Replacing Circuit Packs 5 - 1
Checking the Highest Battery Temperature 5 - 1
Inaccurate Plant Voltage Readings 5 - 2
Temperature Probe Alarm is present 5 - 3
Unexplained Rectifier Failure Alarm and Multiple Rectifier Failure
Alarm 5 - 3
Unexplained Converter Failure Alarm and Multiple Converter
Failure Alarm 5 - 3
Rectifier Id conflict alarm is asserted 5 - 3
Converter Id (Cid) 5 - 3