GE Industrial Solutions Galaxy Vector Rack Mounted Controller J85501M-1 - Manual (Page 73)

Galaxy Rack-Mounted Vector Controller J85501M-1
Issue 2 January 2008 Communications Appendix A - 3
From a terminal connected to the RS-232 port, simply press
ENTER until you are presented with the log-in prompt. The
number of ENTER keys required will depend on the baud rate
you are trying to connect at. The controller will adjust its baud
rate automatically until it recognizes the carriage return
character (ASCII 13) sent by pressing ENTER.
At the "ENTER PASSWORD" prompt type the user or super-
user password. The default password for each level of security is
listed below.
lineage default user password
super-user default super-user password
In general, the user and super-user may view any measurement,
configuration, or control parameter. The super-user can also set
configuration and control parameters as well as change system
passwords.
After receiving the correct password, the controller will respond
with one of the following command line prompts:
* user command line prompt
** super-user command line prompt
When these prompts appear the controller is ready to accept
commands. If the port is idle for 15 minutes then the session will
terminated.