GE Industrial Solutions Galaxy Vector Rack Mounted Controller J85501M-1 - Manual (Page 80)

Galaxy Rack-Mounted Vector Controller J85501M-1
Appendix A - 10 Communications Issue 2 January 2008
• IP address
• Subnet mask
In addition, the following optional information may be
entered:
• Host name
• Default Gateway IP address
Logging In to the
Galaxy Gateway
To login to the Galaxy Gateway, follow these steps:
1. Start-up the PC terminal program (Windows Terminal,
Procomm, etc.) using the following communication
parameters:
Baud : 9600
Data : 8
Parity : none
Stop : 1
Handshaking: none
Flow Control: none
2. Connect the PC to the Galaxy Gateway card’s local port
(RS-232) connector J2 (if it isn’t already connected).
3. Press reset (SW1 – uP reset; see Figure A-3) on the Galaxy
Gateway card.
4. Wait for any diagnostic messages to pass.
5. Wait for the “ENTER PASSWORD:” command line
prompt.
6. Type the Network Administrator password (default:
networkadm).
7. Wait for the “$” prompt.
Configuring
Static Network
Parameters
After a valid password entry, a login header with the following
format will be displayed:
Board Code EBW1 1:3 or BJD1 1:2