GE Industrial Solutions 6KCV301DGF - Manual (Page 43)

43 —————— Digital General Function Card ——————
6KCV301DGF
For example, you can enter :
7 e-1 for 0.700.
2) change the digit you want to modify, by pressing UP and DOWN . The blinking
digit changes its position
3) enter the value you have written, by pressing enter(ENT)
4) abort the edit, by pressing cancel(CANC)
IMPORTANT: after the value is entered, the value is displayed “as best is possible”.
So, it may happen, that the value entered in exponential notation seems not to be
“accepted” by the DGF, for example when it has too many decimals to fit the normal
notation of the keypad. For example, if you enter:
1.0001 e-10
this will be displayed as:
1.000 e-10
while the real value is the value entered. Note also that the value displayed may be
rounded. For example, if you enter:
1.0005 e-10
this will be displayed as:
1.001 e-10
while the real value is the value entered. To exit this menu press cancel(CANC) until
you find:
opt: DGFC
view parameters
k001
MENU STATUS DGF:
In this menu the current status of the card is displayed. It can also be modified. To
access this menu(from
OPTION/OPTION2/MENU) move among menus by pressing UP and DOWN until
you find:
opt: DGFC
status DGFC
k007
then press enter(ENT).
You are now in the status DGF menu. Once enter is pressed the following information
will be displayed:
status IDLE
reset alarm
k008
The first line shows the actual status of the DGF.
The second line shows the actual transition you can perform by pressing enter(ENT).
By pressing UP and DOWN you can change the possible transitions:
The available transitions are: