GE Industrial Solutions 6KCV301DGF - Manual (Page 51)

51 —————— Digital General Function Card ——————
6KCV301DGF
IPA Descriptor Measure
unit
Status of
access
Memo Type Min Max Def. Proc
1000 fvar - WRUN IDLE FLOAT -3.4E+38 3.4E+38 0 -
1199 fvar - WRUN IDLE FLOAT -3.4E+38 3.4E+38 0 -
1200 ivar - WRUN IDLE INT 0 32767 0 -
1299 ivar - WRUN IDLE INT 0 32767 0 -
2000 num - WRUN IDLE HULINT - - 0 -
2099 num - WRUN IDLE UINT - - 0 -
dpar3
PROGRAMMABLE
N/A: not applicable
(1) this parameter is reserved
(2) this parameter is active only at power-on
Status of access:
WIDLE -> write only in IDLE status
WREADY -> write in IDLE and READY status
WRUN -> write in IDLE, READY and RUN status
WALL -> write in all status, including ALERT
READ -> read only parameter
Memo:
IDLE -> store the entire record in flash in IDLE state
RUN -> store the attribute in flash in IDLE status and the value in EEPROM in
RUN status
ATTR -> store only the attribute in flash in IDLE status.
OFF -> do not store anything
2.6.2 Description of parameters
2.6.2.1 Identification parameters
[1]
VERSION Base Software version DGF-BRICKS
[2] IDENTIF Identification, reserved for name and version
of the BRICKS application
[3] ACT-ADDR Address for S-LINK3 cards. The address is
written through parameter 511 and then
automatically copied and stored in parameter
3. The ACT-ADDR cannot be saved in a
parameter file.