Luminex 200 User Manual with IS 2.3 Software - Manual (Page 13)

x
MAP Technology Safety
PN 89-00002-00-144 Rev. B 1 - 3
switch is not a disconnect means; power cords must be removed
from the outlet. Contact Luminex Corporation for further
information.
You must monitor waste levels manually. Do not allow the waste
container to overflow! Empty the waste container each time the
sheath fluid container is filled. Do not place the waste container on
top of the instrument. Contact Luminex Technical Support before
relocating the waste container or rerouting the waste line.
Luminex 200 Analyzer
Laser
The Luminex 200 system classifies per FDA 21 CFR 1040.10 and
1040.11 as a Class II laser product consisting of a Class I laser
product (Luminex 200 analyzer) and a Class II laser product
(barcode reader).
Under NO circumstances should you remove the Luminex 200
analyzer cover! When performing routine maintenance, turn power
to the Luminex 200 analyzer OFF and disconnect the power cord.
All laser apertures are located within the Luminex 200 analyzer and
are contained within a protective housing.
Barcode Reader Laser
Do not stare into the beam or shine it into other people’s eyes.
Mechanical
Warning: If biological samples have been tested with the system,
use your standard laboratory safety practices when handling
system waste.
Warning — Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
Warning: During operation, this system contains exposed,
moving parts. Risk of personal injury is present. Observe all
warnings and cautions.
Warning: During operation, this system contains exposed,
moving parts which could result in puncture hazard. Risk of
personal injury is present. Keep hands and fingers away from the
Luminex XYP instrument slot during operation.
Warning: During operation, this system contains exposed,
moving parts which could result in pinch point hazard. Risk of
personal injury is present. Keep hands and fingers away from the
Luminex XYP instrument slot during operation.