Multichannel Systems Roboocyte2 Manual User Manual

Page 16

Advertising
background image

Roboocyte2 Manual

12

Connecting the Carrier

1. Plug the carrier connector into the according socket located on the Roboocyte2's rear panel.

2. Connect the Compressed Air Outlet to the carrier.

Warning: Confusion of the compressed air's inlet and outlet may destroy the device. Have
a close look at the preceding picture of the Roboocyte2's rear panel and take care to connect
the lines properly.

Connecting the Roboflow

1. Plug the female connector into the male socket of the Roboflow.

2. Then plug the Roboflow connector into the socket on the Roboocyte2's back.

Connecting the Roboocyte2 to the Pressure Line

1. Connect one end of the provided compressed air hose (ID 2.5 mm, OD 4 mm) to the water

separator.

2. Connect the other end to the compressed air inlet on the Roboocyte2's rear panel.

3. Connect the other provided compressed air hose (ID 4 mm, OD 6 mm) to the provided water

separator.

4. Make sure that the pressure line is closed. Connect the free end of the provided compressed air

hose (ID 4 mm, OD 6 mm) to the pressure line.

5. Open the pressure line and apply a pressure of 3 to 3.5 bar.

Warning: Make sure that the compressed air used fulfills all requirements for working with
the Roboocyte2. Otherwise, use of an improper compressed air could result in physical harm
to the hardware. Especially, check that the compressed air is absolutely free of water, oil,
and any particles. Refer to the chapter "Important Safety Advice" for more information.

Connecting the Roboocyte2 to the Power Line

Finally, plug the power cord into the AC power line input. The diameter of the connector
for the power supply is not round. Please turn the flat part of the connector to the left when
looking directly on the back side of the device. Otherwise the connector will be damaged.

Warning: If the air cannot circulate freely around the external power supply, the device may
overheat. Do not shield the power supply by laying anything on top of it. Make sure it is not
exposed to direct sunlight.

Advertising