Multichannel Systems Roboocyte2 Manual - Manual (Page 38)

Roboocyte2 Manual
34
4.2 Main Window of Roboocyte2 Software
After starting the Roboocyte2 software you will see the main window with its four different
sections.
The "Recording" display in the upper left window shows current traces during recordings
which are saved in the “*.r2d” file. (All data between "Robo2.StartRecording(), and
Robo2.StopRecording() in the running script). The lower left window is the "Control"
display showing all recordings performed (All data between "Robo2.StartControlRecording(),
and Robo2.StopControlRecording() in the running script).
Because this display shows also recordings, which are not supposed to be permanently saved
on disk, it will also display voltage and current before impalement or during leak-test routines
to evaluate the quality of an oocyte before recording.
The part in the upper right is reserved for displaying the virtual "Well Plate" in which you can
select oocytes that should be recorded.
The lower right section is displaying the script when the "Script" tab is selected or it is displaying
the log messages when the "Log" tab is selected.