E-Mon E-D5-600800-S*SPL3-V3KIT3 - Manual (Page 5)

DIN-MON™ SMART METER
5 62-0442—04
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
STANDARDS COMPLIANCE
BACnet MS/TP and IP protocol is BTL listed.
LonWorks TP/FT-10 protocol is LonMark ® certified.
PRECAUTIONARY AND SAFETY
INFORMATION
CAUTION
Internal circuit card components are extremely sensitive to electrostatic
discharge. Be careful not to touch internal circuitry prior to discharging
any static buildup on your person. To discharge yourself, touch a
grounded metal object such as conduit or an earth-grounded metal
enclosure.
WARNING
High voltages are present on voltage input connections screw terminals.
Risk of serious injury and/or electrical shock exists. Prior to performing
any wiring operations, review all contents of the user manual and de-
energize the MAINS power switch. Only qualified personnel should
perform installation wiring. Installation wiring must comply with all local
and national electrical codes.