E-Mon E-D5-600800-S*SPL3-V3KIT3 - Manual (Page 54)

DIN-MON™ SMART METER
62-0442—04 54
WARNING
eplace battery with Panasonic part number CR2032 only. Use of another
battery may present a risk of explosion. See owner’s manual for safety
instructions. Internal circuit card components are extremely sensitive to
electrostatic discharge. Be careful not to touch internal circuitry prior to
discharging any static buildup on your person. To discharge yourself,
touch a grounded metal object such as conduit or a metal enclosure
exterior.
The battery cell is mounted in a coin cell holder on the upper left side of the enclosure.
Replace the battery if the low battery warning is on display.
1. Remove the top cover from the meter.
2. Remove the battery from its holder and place on a non-conductive surface.
3. Install new battery into the battery holder.
NOTE: Care should be taken to insure that the replacement battery is installed
the same polarity as the battery that was removed. No damage to unit or
battery will occur if battery is inadvertently installed in the wrong direc-
tion.
4. Dispose of the used battery in accordance with the manufacturer’s instructions.
5. Replace the top cover on the meter and screw in the cover screw.