SecurityMan IPcam-SD - User manual - Manual (Page 10)

6
We strongly recommend that you plug in and configure your IPcam-SD prior to
mounting it.
NOTE: The IPcam-SD must be configured through a “wired” Ethernet connection
before it can be used wirelessly (no Ethernet cable).
1. Attach the antenna to the back of the camera.
2. Insert a Micro SD card (not included) into the Micro SD slot.
3. Using the Ethernet cable provided, connect one end into the “Network”
port of the camera and the other into your network router/switch.
4. Power up the camera by plugging in the cameras power adapter
(5VDC, 2.0A) into the power socket located on the back of the
IPcam-SD and the other end into a power outlet.
NOTE: The IPcam-SD will perform a 30 second self test every time it is powered up.
This test will include the head rotating in a range of motions before coming to a stop.
Next, is to proceed to CMS installation below to complete camera setup.
Camera Setup
Software (CMS) Installation
System Requirements
• Operating System: Windows XP, Vista, 7 and 8 (32-bit/64-bit OS)
• Processor: Intel Pentium 4 (2.0GHz or above)
• Video Card: NVIDIA GeForce 6800 equivalent or better
• Memory: 2GB RAM
• Storage: 1GB available hard drive space
• Internet: Broadband Internet connection