SecurityMan IPcam-SD - User manual - Manual (Page 89)

85
CHANNEL
The CHANNEL selection is defaulted to channel 1 and cannot be selected.
ENABLE
The ENABLE option is used to enable (checked) and disable (default, un-
checked) motion detection event recording and notifications.
SENSITIVITY
The SENSITIVITY select drop down allows you to set the blind sensitivity level.
This sets the trigger level that will activate the recording and alerting functions
when applicable. To set the sensitivity level for your IPcam-SD, move your
cursor over to the drop down arrow and left click it to display the options
available. The sensitivity level ranges from Lowest, Lower, Middle (default),
High, Higher, and Highest.
SCHEDULE
The SCHEDULE button lets you set up to 4 different recording periods for
each day of the week. By doing this, you can create schedules that will allow
you to detect video blind period. Video blind is enabled to detect the camera
integrity. When the camera is blocked or does not display any image, the
operator will get an alert if it happened in this scheduled period.
NOTE: This schedule is dedicated for video blind schedule when video blind
should be enabled or disabled, not related to the schedule used in video and
snapshot.
ACTION AREA
The ACTION AREA lets you specify what the IPcam-SD should do when a blind
event occurs and consists of the following option:
• Alarm Output – enables the IPcam-SD’s alarm output device that is connected
to the I/O terminal (output terminal supports 5VDC) to come
on when video blind occurs.
• Record Channel – enables video recording to save to the MicroSD card of
the IPcam-SD.
• Snapshot - enables photo snapshots to save to the MicroSD card of the IPcam-SD.
PTZ ACTIVATION
The PTZ ACTIVAION button lets you select the tour/preset that you would
like to use whenever a blind event has occurred. This feature also consists of
a DELAY (post-movement) time frame that lets you dictate how much longer
the IPcam-SD should keep touring after its default 10 second (per blind event
recording has expired.
NOTE: To use PTZ Activation for Preset and Tour, be sure to pre-set the
Preset positions and preset the Tour positions in the “PTZ” section of the CMS
software.
NOTIFICATION AREA
The NOTIFICATION AREA lets you specify how you (the user) would like to be
notified when and if a blind event occurs. The options available are:
• Show Log – shows event activity in the system event log.
• Send Email – enables email alerts with picture attachments to the email
setup in the NetService section of the CMS software. To set
the number of email per event, go to REC/PlayBack/Snaphot/
Pictures (system default is 2 pictures per event).