Yokogawa ADMAG AXF - Manual (Page 93)

IM 01E20D01-01E 6-31
6. OUTLINE
᭹ Table of Optional Specifications (Size 2.5 mm (0.1 in.) to 400 mm (16 in.)) (continued)
Code
Submersible Sanitary
Applicable Model
General
Item Specifications
᭺ ᭺ ᭺ ᭺ – – – X2
Epoxy Resin Coating Epoxy resin coating which has alkali-resistance instead of standard
polyurethane resin coating. The color is same as standard type.
Material Certificate
High Anti-corrosion
Coating
Three-layer coating (polyurethane coating on two-layer epoxy resin
coating) in the same range as that for the standard coating. The color is
same as standard type. Salt/alkali/acid/weather-resistance.
Reproduced material certificates for :
PFA/polyurethane: Pipe, electrodes, grounding rings/grounding
electrodes, flanges or mini flanges, adapters (for sanitary type)
Ceramics: only grounding rings or grounding electrodes or union joint
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ M01
᭺ ᭺ ᭺ ᭺ – – – X1
T26-3.EPS
᭺: Available –: Not available
Hydrostatic Test The test verifies the absence of leaks by applying the following water
pressures (which are determined under process connection conditions) to
linings for ten minutes. Test results are described in the Note column of a
test certificate (QIC).
Water Pressure:
1.5 MPa
3.0 MPa
6.0 MPa
1.25 MPa
Process Connection:
ANSI Class 150, DIN PN10, JIS 10K
ANSI Class 300, DIN PN16, JIS 20K
DIN PN40, Union joint (Ceramics lining)
JIS F12
Calibration Certificate Level 2: The Declaration and the Calibration Equipment List are issued.
Level 3: The Declaration and the Primary Standard List are issued.
Level 4: The Declaration and the Yokogawa Measuring Instruments Control
System are issued.
Enhanced Dual
Frequency Excitation
(*6)
Available for 25 to 200 mm (1.0 to 8.0 in.) sizes.
Products are delivered with the Standard dual frequency excitation mode
and the Enhanced dual frequency excitation mode enabled.
Although the meter factors for the Standard dual frequency excitation mode
and the Enhanced dual frequency excitation mode are inscribed on the
nameplate, the flow calibration of optional code HF1 is not performed in
Enhanced dual frequency excitation.Excitation mode select optional code
HF2 when an accurate flow measurement is required.
Available for 25 to 200 mm (1.0 to 8.0 in.) sizes.
Products are delivered with the Standard dual frequency excitation mode
and the Enhanced dual frequency excitation mode enabled.
The meter factor for the Enhanced dual frequency excitation obtained by
flow calibration is inscribed on the nameplate and set into the combined
converter in addition to the meter factor for the Standard dual frequency
excitation.
Vent Hole With a vent hole provided for permeable fluids (such as nitric acid,
hydrofluoric acid, or sodium hydroxide at high temperature).
Available only for a PFA lining flange type tube.
᭺ ᭺ ᭺ ᭺ – – – H
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ HF1
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ HF2
᭺ ᭺ ᭺ ᭺ ᭺ – – T01
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ L2
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ L3
᭺ ᭺ ᭺ ᭺ ᭺ ᭺ ᭺ L4
Explosion proof
Remote
Flowtube
Integral
Flowmeter
Remote
Flowtube
Remote
Flowtube
Integral
Flowwmeter
Remote
Flowtube
Integral
Flowmeter
Oil-prohibited Use with
Dehydrating Treatment
Electrodes, linings, and grounding rings are assembled and packed with
polyethylene including desiccants after being cleaned with water and
acetone and dried with air. The label ‘OIL & WATER FREE’ is affixed.
Painting Color Change Coated in black (Munsell N1.5 or its equivalent.)
Coated in jade green (Munsell 7.5 BG 4/1.5 or its equivalent.)
Coated in metallic silver.
᭺ ᭺ ᭺ ᭺ – – – K5
᭺ ᭺ ᭺ ᭺ – ᭺ ᭺ P1
᭺ ᭺ ᭺ ᭺ – ᭺ ᭺ P7
᭺ ᭺ ᭺ ᭺ – ᭺ ᭺ P2
AXF***G-
D E F G
AXF***G-
N P
AXF***C-
D E F G
AXF***C-
N P
AXF***W
- N P
AXF***H-
D E F G
AXF***H-
N P