LumaSense Technologies INNOVA 1412i - Manual (Page 123)

Chapter 10
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 123 of 202
6. You are now able receive printed output from the gas monitor in
the terminal window that you have just created. Below is shown a
measuring task session.
10.4 Additional Parameters Required
The other output parameters which determine the format of print-
outs are shown in Table 10.2 together with available choices and
factory default values.
Table 10.2 Parameters which determine the format of print-outs
from the monitor
Display Text Acceptable
Values
Default
Value
PRINT EACH GAS? No, Yes Yes
(if print each gas is no) PRINT
GAS N*?and/or Air Pressure
No, Yes No
SELECT TEXT LINE TERMINATOR CR, LF, CR-LF CR-LF
If one chooses to PRINT EACH GAS, then all gases, which have
been measured, will be printed out. If one does not choose to PRINT
EACH GAS then the user is given the chance to choose which of the
gases (A-E) and water (W) should be printed out – PRINT GAS A?
and so on.