Gas to be used during span calibration – LumaSense Technologies INNOVA 1412i User Manual
Page 164
Advertising
Chapter 12
______________________________________________________________________
_____________________________________________________________________________
BE6025-15
1412i Photoacoustic Gas Monitor
LumaSense Technologies A/S
Page 164 of 202
Gas to be Used During Span Calibration
The gas you need to use during span calibration must be the gas you
wish to measure with the filter.
Type of Span Calibration – Single-point or Two-point?
Fig.12.15a Graph showing a non- linear span-calibration curve which can
be plotted using the signals measured during a two-point span
calibration task
Fig.12.15b Graph showing a non- linear measurement curve
Advertising