Triton 97XX Series Operation Manual - Manual (Page 164)

TRITON SYSTEMS, INC. 5-109
O
PERATION
M
ANUAL
- M
ODEL
97XX-Series SECTION 5 - MANAGEMENT FUNCTIONS
Normally, the PIN WORKINGKEY contains only one part. How-
ever, some keys may contain multiple parts. If this is the case,
separate individuals will hold the parts. If your key has multiple
parts you must answer the question “ANOTHER KEY PART?”, with
a YES until all parts are entered.
The CHECK DIGIT that appears after all parts of the PIN
WORKINGKEY have been entered is similar to the checksum that
is used to verify that the data programmed into a memory device
such as an EPROM is correct. The CHECK DIGIT can be verified
by doing a RECEIPT PRINTER TEST from the DIAGNOSTICS
Menu and comparing the PIN WORKING KEY CHECK DIGIT on
the printout to the original receipt printout from the initial terminal
setup. If the CHECK DIGIT is different from the original, and the
terminal is not operating correctly, the PIN WORKING KEY is cor-
rupt, and you should contact your service organization for assis-
tance.
E
RROR
C
ONDITIONS
:
If the PIN WORKING KEY is not entered correctly, no message
traffic can take place, so be sure to enter the key accurately. If your
second entry of the key does not match the first entry, you will be
warned and allowed to start over with the first entry.