Entering the combination, Changing the combination, Lockout feature – Triton RL5000 User Manual User Manual
Page 182
A-2
M
ODEL
RL5000 S
ERIES
U
SER
M
ANUAL
Entering the Combination
The electronic lock combination consists of six digits. Upon arrival, the combination
of the lock should already be set at 1-2-3-4-5-6. After installation of the safe has
been completed, perform the following steps:
1.
Enter the preset combination and check for proper operation. After each
keypress, the lock will beep. After the final digit has been entered, the lock will
beep twice and the open period will begin.
2.
When a valid combination has been entered, the operator will have approximately
3 seconds to open the lock.
3.
To open the lock, turn the dial clockwise.
4.
After the lock is opened, the door latch may be turned and the safe opened.
Changing the Combination
To change the combination of the lock, simply follow these directions.
•
Enter six zeros.
•
Enter the current combination. (Initially set at 1-2-3-4-5-6)
•
Enter the new combination twice.
•
The combination is now changed. Enter the new combination to open the lock.
Lockout Feature
The lock includes a WRONG TRY PENALTY lockout feature that prevents entry
from unauthorized personnel. This feature performs as follows:
•
Entry of four consecutive invalid combinations will disable the lock for 5 minutes.
•
During this lockout period, the panel LED will flash every 10 seconds. During
this time no other combination entries will be allowed.
•
At the end of the lockout period, if two more consecutive invalid combinations
are entered, the 5-minute lockout period will restart.