Triton RL5000 User Manual - Manual (Page 57)

3 7
C
URRENCY
H
ANDLING
TDM-100/150/200/250
Dispensers
and reject cassettes can be accessed from
the front. Release the locking pin and move
the mounting latform back and forth slightly
to
ensure the pin snaps back into place,
locking the mounting platform into the
service position.
5. To remove the note cassette, grasp the
cassette handle and pull in a firm but
controlled manner to release the cassette
from the snap catches. Try to use only
the minimum amount of force to release
the cassette! The cassette will only
move a few inches! Once released from
the snaps, you can slide the cassette
out of the mechanism. Place the
cassette on a level flat surface for
servicing.
Rotate mechanism to service position.
4. Pull the pin down to release the swivel
mounting platform. Slowly turn the
tray clockwise 180° so that the note
Removing note cassette.
Service position (180°).
(TDM-100)
(TDM-150)
Removing the
Currency Cassette
1. Ensure the terminal is not in use
before removing the note cassette!
Removing the note cassette while the
machine is in operation (processing
customer transactions, performing
close operations, etc.) can cause the
terminal to enter an “Out of Service”
condition!
2. Open the outer fascia panel to gain
access to the security container door,
using the key lock on the front of the
panel. Open the electronic lock on the
security container door and open the
door to gain access to the dispensing
mechanism.
3. To gain access to the cassettes, pull
the dispenser slide tray out to its fully
extended position. Rotate the
mechanism mounting platform to the
service position. To do this, locate the
spring-loaded locking pin on the
underside of the slide tray. This pin
lets you lock the dispenser’s swivel
mounting platform into the Service/
Operate positions.
Pull release pin for swivel platform.