Triton RL5000 User Manual - Manual (Page 64)

4 4
M
ODEL
RL5000 S
ERIES
U
SER
M
ANUAL
IMPORTANT! If you remove the reject
vault with power applied, the terminal
will sense this and automatically reset
the rejected note count to ZERO. There-
fore, to ensure an accurate rejected note
count NEVER REMOVE THE RE-
JECT VAULT WITH POWER AP-
PLIED WITHOUT CHECKING FOR
AND REMOVING ANY REJECTED
NOTES.
2. To remove the reject vault, grasp the
vault handle with one hand while hold-
ing the mechanism in place with the
other hand. Pull the vault out slightly.
Place one hand underneath to support
the vault as you slide it completely
out of the unit. Place it on a level sur-
face.
Opening the Reject Vault
The reject vault is locked when it is removed
from the dispenser. A color indicator win-
dow shows GREEN when the vault is
opened for collection and when it is ready
for use. This condition is also referred to as
the PRIME position of the color window.
The color window shows RED when the
vault is inserted into the dispenser and will
show red until it has been removed from the
dispenser and opened for collection.
Remove the vault seal (if applicable). Turn
the small handle on the front counterclock-
wise and lift the lid. Release the handle. Col-
lect the rejected notes.
Opening reject vault top.
Closing the Reject Vault
After removing any rejected notes, turn the
small handle about a half-turn counterclock-
wise and close the lid. Allow the handle to
return to the position of the seal bracket. At
this point, the vault is primed and the color
window should be showing GREEN. If ap-
plicable, apply a new vault seal and lock the
small handle to the seal bracket.
Removing reject vault.
Small Handle
Indicator
Optional Reject Vault
**CAUTION**
DO NOT RECYCLE REJECTED
NOTES INTO A CASSETTE!
Doing so could cause more rejects
and/or currency jams.
Closing reject vault top.