Alicat MC Series Mass Flow Controller - Manual (Page 79)

79
DB15 – Pin-Out Alicat Style
Pin Number Function
1 Ground
2 Primary Analog Signal Output
3 Ground
4 N/C
5 Power Supply (+Vdc)
6 N/C
7 N/C
8
Analog Tare (meters — when grounded)
Analog Set-Point Input (controllers)
9 Power Supply Common
10 Ground
11 Secondary Analog Signal Output / fi xed 5.12Vdc
12 N/C
13 RS-232 RX (receive) or RS-485 –
14 Ground
15 RS-232 TX (send) or RS-485 +
Check your device’s calibration certifi cate and user manual for the actual electrical input/
output requirements, as all instruments are custom confi gured to some extent.
NOTE: Pins 1, 3, 9, 10, and 14 are connected together inside of the device and are
common grounding points.
N/C = Not Connected/Open (can be used for custom pin assignments – please consult factory).
The following pin-out chart describes the safest and generally compatible arrangement
when connecting a non-Alicat DB15 wire to a DB15 equipped Alicat. Not all features may be
available between brands, but the common denominators are featured in our DB15 offerings,
along with some options for customization.
DB15 Pin-Outs
If your instrument was ordered with a DB15 connection,
be sure to check the Calibration Label on the device and
reference the appropriate pin-out diagram.
Male Connector Front View Female Connector Front View
8
15 13 11 9
2 5
8
15 13
11 9
2 5