Changing the option settings of storage system – HP StorageWorks XP Remote Web Console Software User Manual
Page 134
1.
Click the System Option tab, and then click Clear SIM (see
).
2.
On the Clear SIM confirmation dialog box, click Yes to clear all remote copy SIMs from the
connected storage system, or click No to cancel your request to clear SIMs.
3.
If you clicked Yes, the storage system verifies that the existing SIMs are being cleared.
When all SIMs have been cleared, the storage system MESSAGE lamp on the HP disk array control
panel turns off. This may take up to 30 minutes. If there are any existing SIMs which are not related
to remote copy operations, the MESSAGE lamp will not turn off.
Changing the Option Settings of Storage System
The information for the storage system's option settings is displayed if you select Subsystem Option
from the tree on the System Option window.
Figure 47 Option Settings List for the Storage System
•
Activities: Number of volumes in concurrent initial copy operations (1 to 512).
•
Activities (CU): It shows whether the CU-by-CU setting of concurrent initial copy operations
will be enabled or disabled.
•
Path Watch: Time for monitoring blockade in the paths (2 to 45 seconds).
•
Path SIM Watch: Time for monitoring SIMs that are reported when paths are blocked (2 to
100 seconds).
•
SIM Report: Reporting status for service-level remote-copy SIMs (SIM type: except DEVICE) to
the host(s). Report or No Report will be displayed.
To change the option settings of the storage system:
1.
Click the System Option tab, and then select Subsystem Option in the tree (see
).
2.
Right-click the list to display the pop-up menu, and click System Option to open the System
Option dialog box (see
“Option Settings List for the Storage System” (page 134)
).
3.
On the System Option dialog box, change the storage system options. When the System
Option dialog box opens, current settings are displayed.
4.
Click Set to close the System Option dialog box. The desired change(s) is/are now displayed
in the preview list. To cancel the change(s), click Cancel.
5.
Verify the desired change(s) in the preview list (see
“System Option Dialog Box” (page 135)
).
•
To change the settings, right-click the preview list, click Modify, make the desired changes,
and close the dialog box. The preview list displays the updated information.
•
To omit the settings, right-click the preview list, and click Delete. The changes are cancelled.
134
Performing TrueCopy for Mainframe Configuration Operations