HP XP7 Storage - Manual (Page 279)

Table 90 SSB codes that are returned by raidcom add rcu_path command (continued)
raidcom add rcu_path
Description Error code Executing/
Async Error message
SSB2 SSB1
The serial number, the product ID, or the SSID of the target
storage system is incorrect. 3000 2E20 Async Get Command Status
A logical path cannot be added because the specified RCU is
not registered. 3001 2E20 Async Get Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Async Get Command Status
An RCU path cannot be added because the number of valid
paths exceeds the maximum. 3100 2E23 Async Get Command Status
The operation cannot be done because the number of paths
becomes less than the least path number. 3101 2E23 Async Get Command Status
The port attribute is not Initiator (MCU). 840A 2E30 Executing CMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid. 3001 2E31 Async Get Command Status
Command cannot be executed because the serial number is not
unified in the specified path. 3101 2E31 Async Get Command Status
The command cannot be accepted because the DKC is busy.
After a while, execute the same command. 00EE 2ED6 Executing CMDRJE
An internal error occurred. 3005 2ED6 Async Get Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid. 3300 2ED6 Executing CMDRJE
The specified parameter is invalid. Check the HP XP7 RAID
Manager Reference Guide. 3002 2EF3 Executing CMDRJE
Table 91 SSB codes that are returned by raidcom delete rcu command
raidcom delete rcu
Description Error code Executing/
Async Error message
SSB2 SSB1
CU# on the RCU exceeds the effective range. 3001 2E00 Executing CMDRJE
Invalid product ID or path registration ID. 3005 2E00 Executing CMDRJE
Command cannot be executed because the parameter of
specified RCU is invalid. 3008 2E00 Async Get Command Status
The value of specified port# on the side of RCU is invalid. 3200 2E00 Executing CMDRJE
The CU number is out of effective range. 7100 2E00 Async Get Command Status
The value of specified port is invalid. 8400 2E00 Executing CMDRJE
/Async Get Command Status
The operation cannot be done because the microcode is being
changed. 8004 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
Error messages and error codes 279