HP XP7 Storage - Manual (Page 32)

For XP1024/XP128 Disk Array, RAID Manager supports four types of port names for host groups:
•
Specifying the port name without a host group: CL1-A CL1-An, where n is the unit ID if
there are multiple RAID storage systems
•
Specifying the port name with a host group: CL1-A-g, where g is the host group CL1-An-g,
where n-g is the host group g on CL1-A in unit ID=n
The following ports can be specified for XP12000 Disk Array/XP10000 Disk Array and
XP24000/XP20000 Disk Array:
Option Option Option Basic -
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL5
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL6
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL7
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL8
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL9
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLA
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLB
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLC
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLD
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLE
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLF
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLG
•
Target ID: Defines the SCSI/fibre target ID (TID) number of the physical volume on the specified
port.
•
LU#: Defines the SCSI/fibre logical unit number (LU#) of the physical volume on the specified
target ID and port.
NOTE: In case of fibre channel, if the TID and LU# displayed on the system are different
than the TID on the fibre address conversion table, then you must use the TID and LU# indicated
by the raidscan command in the RAID Manager configuration file.
•
MU# for Business Copy (HOMRCF): Defines the mirror unit number (0 - 2) to use the redundant
mirror for the identical LU on the Business Copy. If this number is omitted, it is assumed to be
zero (0). The cascaded mirroring of the S-VOL is expressed as virtual volumes using the mirror
descriptors (MU#1-2) in the configuration definition file. The MU#0 of a mirror descriptor is
used for connection of the S-VOL. The mirror descriptor (MU#0-2) can be used in Business
Copy and Snapshot. MU#3-63 can be used in Snapshot only.
S-VOL P-VOL SMPL Feature
MU#1 - 63 MU#0 MU#3 - 63 MU#0-2 MU#3 - 63 MU#0-2
Not valid Valid Not valid Valid Not valid Valid Business Copy
Not valid Valid Valid Valid Valid Valid Snapshot
32 RAID Manager software environment