HP XP7 Storage - Manual (Page 229)

The following describes the SSB codes that are returned by the replication commands and the
configuration setting command (raidcom).
SSB codes returned by the replication commands
When a replication command returns an SSB code, refer to the troubleshooting information in the
user document for the product as follows:
Product returning the SSB code Command
Continuous Access Synchronous •
paircreate
• pairresync
•
pairsplit
• horctakeover
•
horctakeoff
Continuous Access Journal • paircreate
•
pairresync
•
pairsplit
• horctakeover
•
horctakeoff
Business Copy •
paircreate
•
pairresync
• pairsplit
Database Validator •
raidvchkset -vt
• raidvchkset -vs
Data Retention raidvchkset -vg
Thin Provisioning • raidvchkset -vext
SSB codes returned by the configuration setting command (raidcom)
Executing the configuration setting command (raidcom command) may return an SSB code. An
error may occur whether the command is executed synchronously or asynchronously. For an
asynchronous error, the error information is displayed on the console by executing raidcom get
command_status command. When the error message shows "CMDRJE" or "Get Command Status",
check the contents of SSB1 and SSB2. You can verify a content of an error by the raidcom get
error_message command. When you specify the SSB code with the raidcom get error_message
command, make sure not to specify a wrong SSB code.
The following tables provide information about each SSB code returned by the configuration setting
command (raidcom command). If you see an error not described in the tables, contact HP Technical
Support.
Error messages and error codes 229