Vaisala AWS330 - Manual (Page 115)

Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA ______________________________________________________________________ 113
Software Configuration Procedure
CAUTION Configure AWS330 by following this procedure step by step.
NOTE Navigating in the screens is explained in section General Instructions on
Using AWS Client on page 106. Read it carefully.
1. Set Common Parameters as described on page 114.
2. Set Location Parameters as described on page 115 (optional).
3. Set time as described in section Time and Time Zone on page 116.
4. Set Sensor Parameters as described on page 118.
5. Select the message type you want to use with AWS330. For
message type descriptions, see section Observation Messages on
page 27.
6. Set message transmission interval for the selected message type as
described in section Message Intervals on page 120.
7. Select observation messaging protocols(s) as described in section
Messaging Protocols on page 121.
8. Select alarm messaging protocol(s) as described in section
Alarming Protocols on page 123.
9. Set messaging protocol -dependent parameters. Based on the
protocol(s) chosen in steps 7 and 8, refer to following section(s):
- TCP-Socket (Virtual Com Port) on page 124.
- File Transfer Protocol (FTP) on page 126.
- eMail (SMTP) on page 128.
- GSM SMS on page 131.
- Local Serial Line on page 132.
- For CSD dial-in, there is no protocol-dependent configuration
required.
10. Set up telemetry configuration:
- For IP over GPRS telemetry, see section GSM Modem on page
133 and GPRS on page 134.
- For data call telemetry, see section GSM Modem on page 133
and CSD Dial-In (Data Call) on page 136.
- For IP over Ethernet telemetry, see section Ethernet on page
137.
11. Set up alarm limits as described in Alarms on page 138.
12. To make parameter updates effective, reset the AWS330 system
using AWS Client. From the AWS Client menu, select
Maintenance - Reset - Immediate.