Vaisala AWS330 - Manual (Page 218)

User's Guide ______________________________________________________________________
216 _________________________________________________________________ M211296EN-B
9. To monitor different telemetry related services, a shell command
can be used to enable extra output. Command format is
DO <Service Name> DEBUG_ON <Port>
where
<Service Name> =
Name of the service to monitor; see Table
59 below
<Port> = Port where the information is sent to; see
Table 60 below
For example, the following shows how this command can be used
to monitor EMAIL operation remotely via TCP service connection:
/> DO EMAIL DEBUG_ON VCOM1
Debugging enabled->VCOM1
The following services can be monitored:
Table 59 List of Service Names
Service name Description
FTP FTP message transport
VCOM0 TCP socket message transport
EMAIL eMail message transport
SMS SMS message transport
GSM_Modem GSM modem control
NTP NTP timekeeping
Depending on the used connection, the following ports are
available:
Table 60 Debug Ports
Connection Port Name
Local service connection to COM0 COM0
Remote service connection using TCP socket VCOM1
Remote service connection using CSD dial-in DSI486_0_1
To stop monitoring a service, use the following command:
DO <Service Name> DEBUG_OFF
For example, to stop monitoring the EMAIL service:
/ > DO EMAIL DEBUG_OFF
Debugging disabled