Aalborg TIO Totalizer I/O Flow Monitor/Controller - Manual (Page 19)

15
Device Function: Flow Controller
Figure 5.4: TIO PI Screen (based on device function)
Device Function: Flow Meter
51.01
A:D litr/min
T1: 254898.0 litr
51.01
KF:D litr/min
T2: 436.5 litr
51.01 litr/min
A:D KF:D
T1: 254898.0 litr
T2: 436.5 litr
51.01 litr/min
A:D KF:D
Events Reg: No Events
PO:E U/P: 1.000 litr
DO# 1: Pulse Output
DO# 2: Disabled
51.01
S: 51.0 litr/min
T1: 254898.0 litr
51.01
KF:D litr/min
T2: 436.5 litr
51.01 litr/min
A:D KF:D
T1: 254898.0 litr
T2: 436.5 litr
51.01 litr/min
S 51.0 0.0s
CS: 1 0.0 0
M:D L:O S: Off
5.1.1 Set Point Control
(only for devices set as controller)
When TIO is configured as controller it can be used to control set point value for
mated flow controller using analog output interface.
NOTE: Your TIO device input / output jumpers were factory configured
according to your order. Make sure the mated flow controller has
an analog input interface compatible with the TIO analog output
configuration. Before applying the power and process signals make
sure the input /output jumpers are installed in the correct position
(See Table 6.5).
,