Aalborg TIO Totalizer I/O Flow Monitor/Controller - Manual (Page 76)

73
INDEX NAME DATA TYPE NOTES
71 Total1_Volume_BkUp float
Totalizer#1 backup volume in %s (saved every 6
minutes)
72 Total1_AutoReset uint
Reset Total. Volume value when Totalizer value
equals Limit volume 0 - No, 1 - Yes
73 Total1_AtoResetDelay uint
Delay in seconds before AutoReset will reset
Totalizer#1 volume reading to zero [0-3600]
74 Total1_Reserved uint Totalizer#1 reserved
75 Total2_Mode uint Totalizer#2 mode: (0-Disabled, 1-Enabled)
76 Total2_Config uint Totalizer#2 configuration (0-Count Up, 1-Count Down)
77 Total2_FlowStart float Start tot. at flow [0-1.0 fraction notation %F.S.]
78 Total2_VolStop float Limit volume in %s, 0 = disable
79 Total2_PowOnDelay uint Totalizer#2 power on delay in second [0-3600]
80 Total2_Volume_BkUp float
Totalizer#2 backup volume in %s (saved every 6
minutes)
81 Total2_ReloadVolStop uint
Reload VolStop value when Totalizer reading counts
down to zero 0 - No, 1 - Yes
82 Total2_ReloadDelay uint
Delay in seconds before Reload VolStop value when
Totalizer reading counts down to zero [0-3600]
83 Total2_10SecBackUp uint
Enable or Disable every 10 seconds EEPROM backup
(reserved for future version release)
84 Total2_Reserved uint Totalizer#2 reserved
85 Flow_Pulse_Mode uint Flow Pulse Output Mode (0=Dis'd, 1=En'd)
86 PulseFlowStart float Start pulse output at flow [0-1.0 fraction notation %F.S.]
87 Units_Per_Pulse float Units per pulse scaling
88 Active_Low_Time uint
Number of ms output will be activated when pulse is
developed
89 Flow_Pulse_Reserved uint Pulse Output Reserved
90 FlowCondMode uint 0 - No conditioning, 1 - NRF, 2 - Running Average
91 Flow_NRF_NSample uint Flow NRF Number of Samples [1 - 32]
92 Flow_NRF_ErrLimit float Flow NRF Error Value [0.05 10.0] %F.S. (FN)
93 Flow_NRF_TimeLimit uint Flow NRF Time Interval [0-199], 0 - disabled
94 Flow_Damping uint Reading Damping 0-500 ms
95 Flow_Window uint Flow running average window [0-32] 0-disable
96 FlowLinearizer uint Flow Linearizer: On (1), Off (0)
97 Flow_SC_Reserved uint Flow Signal Conditioner reserved
98 FlowTbl[0].FlowPFSIn float Flow Linearizer Index 0 PFS In (must be 0.0)
99 FlowTbl[0]. FlowPFSOut float Flow Linearizer Index 0 PFS Out (must be 0.0)
100 FlowTbl[1]. FlowPFSIn float Flow Linearizer Index 1 PFS In [0.0 – 1.0]
101 FlowTbl[1]. FlowPFSOut float Flow Linearizer Index 1 PFS Out [0.0 – 1.0]
102 FlowTbl[2]. FlowPFSIn float Flow Linearizer Index 2 PFS In [0.0 – 1.0]
103 FlowTbl[2]. FlowPFSOut float Flow Linearizer Index 2 PFS Out [0.0 – 1.0]
104 FlowTbl[3]. FlowPFSIn float Flow Linearizer Index 3 PFS In [0.0 – 1.0]