Aalborg TIO Totalizer I/O Flow Monitor/Controller - Manual (Page 47)

In the example shown above, all PSP Steps are enabled. Each PSP Step
assigned to a corresponding bit in the PSP Steps Register. In order to
change PSP Step mask settings user should select desired Step using UP
and DN buttons and then press RIGHT button. The asterisk will appear/
disappear on the right side of the corresponding Step. The asterisk
represents that Step is enabled. In order to disable Step, the correspon-
ding asterisk must be removed. Use ENT button to accept and save new
PSP Steps mask settings in device non volatile memory.
d) PSP Steps Settings (Numerical Entry)
By using PSP Steps Settings menu selection the user can assign required
set point and time values for each step in the program. A typical display
with PSP Steps Settings selection is shown below.
In the example shown above, Step 01 is selected. For each step there are
two parameters: set point value in %F.S. and time interval in seconds. In
order to change PSP Step settings user should select desired step using
UP and DN buttons and then press the ENT button. The cursor in the
selected (highlighted) parameter will start flashing. Use UP, DN, LEFT,
RIGHT buttons to adjust desired value. Then press ENT button to
accept and save the new PSP Step settings in the device’s nonvolatile
memory.
5.3.17 Submenu “Event Register Menu”
TIO is equipped with a self-diagnostic Alarm Event Register which is available via
the digital interface and on the screen LCD indication. Use the “Diagnostic Menu”
to navigate to “Event Register Menu” option.
43
PSP Steps Masc:
S02 0.0% 10s [*]
S03 25.0% 25s [*]
S04 25.0% 10s [*]
S05 50.0% 25s [*]
PSP Steps Settings:
S02 0.0% 10s [*]
S03 25.0% 25s [*]
S04 25.0% 10s [*]
S05 50.0% 25s [*]
S01 0.0% 0s [*]
S01 0.0% 0s [*]