Aalborg TIO Totalizer I/O Flow Monitor/Controller - Manual (Page 85)

82
COMMAND
NAME
DESCRIPTION
NO.
COMMAND SYNT
A
X
COMMAND
ARGUMENT 1
ARGUMENT 2
ARGUMENT 3
ARGUMENT 4
RESPONSE
To
talizers
Sets and controls action of the flow T
o
talizers.
NOTE: Start T
o
talizer at
Flow value must be entered for in %FS (0.0 – 100.0). Limit volume must be entered in currently selected EU. If T
o
talizer hit limit
event is not required, set “Limit V
o
lume” value (argu-
ment 4) to zero. T
o
talizer#1
can be configured to Count Up only (argument M is not supported). T
o
talizer#2 can
be configured to Count Up or Count Down mode. When configured to Count Down mode, limit volume must be more than zero. To
talizer#1 reading is stored
in EEPROM (non-volatile) memor
y. Power cycle will
not affect T
o
talizer#1 read-
ing.T
otalizer#2 reading is
backed up in EEPROM with 6 minutes inter
val. Power
cycle may affect T
o
talizer#2
reading. T
o
talizer#1 cannot
be reset if ResetLock (EE index 70) value set to 1.
11
T
1 (T
otalizer #1)
2 (T
otalizer #2)
Z (Reset to zero)
T1Z or T2Z
C Start flow and Event Condition
<value> (start T
o
talizer at flow)
%FS [0.0 – 100.0]
<value> (Limit volume In current volume based EU)
T1C:2.5, 0.0 or T2C:2.0,20580.5
P Power On Delay
<value> (0-3600 sec.)
T1P:10 or T2P:20
D (disable T
otalizer)*
T1:D or T2:D
E (enable T
o
talizer)
T1:E or T2:E
R (read current T
o
talizer
volume)
T1R:<value> or T2R:<value> (in current EU)
S (read current settings status)
T1S:Mode,Direction,Start Flow
,LimitV
olume,
PowOnDelay
,AutoResetMode,
AutoResetDelay Example: T1S:E,0,0.5, 2045.2,10,0,5
A Set Auto Reset/Reload mode
<value> [0-1] 0 – Disable 1 – Enable
T1A:0 - disabled Or T2A:1 - enabled
I Set Auto Reset/Reload Inter
val delay
<value> [0-3600 sec.]
T1I:2 Or T2I:0
B Restore T
o
talizer#1
value from EE backup
T1B Not supported by T
o
talizer #2.
M To
talizer#2 counting
direction configuration
<value> [0-1] 0- Count Up 1-Count Down
T1M:0 Not supported by T
o
talizer #1.