Campbell Scientific RTDAQ Software - Manual (Page 104)

Section 5. Program Creation and Editing
Note that outputs for a sensor don’t have to be added in the same sequence as
the measurement. You can even drag and drop the outputs to rearrange their
order. Note also that multiple outputs can be added for any one sensor. For
example, you may want to store the maximum and minimum air temperature as
well as the average.
Table-based dataloggers have a TableName field as opposed to
an array ID. There is also a check box used to store data to a PC
card or SC115, if that functionality is supported by the
datalogger model (see below for more information). NOTE
The Advanced Outputs check box in the lower left corner provides more
output options:
5-44