Campbell Scientific RTDAQ Software - Manual (Page 217)

Section 7. Monitoring Data in Real-time
After you have used the available options in the FFT/Histogram options
screen for some time, you may find certain groups of settings that are useful to
you again and again. To facilitate the easy recall of such configurations, you
may save all of the current option screen selections in a configuration file.
When you run RTDAQ at a later time and open the FFT/Histogram screen,
you can load those settings into the window by simply loading the
configuration file that you previously saved. This allows you to set the options
for the screen more easily and reliably. This method also allows you to select
from among multiple saved scenarios, choosing the scenario that is best for the
data you currently wish to display.
Press Save Graph Configuration to save the current option settings to a file.
Specify a name for the file and browse to the folder in which you would like
the configuration to be saved.
Press Load Graph Configuration to load settings that have been previously
saved. Browse to the file containing your saved settings and press Open.
Those settings will be applied immediately to the FFT/Histogram screen.
7.9.9 Accepting or Abandoning Changes to the FFT/Histogram
Options
After setting the various options for the FFT/Histogram display, press the
Apply button to immediately put those changes into effect. The options screen
will remain open, and the settings will be applied. Press the OK button if you
would like to apply the settings and exit the Options screen. Press Cancel if
you would like to abandon any changes made to the settings since the screen
was opened. Press Help to access the online help topic for this screen.
7-65