Campbell Scientific RTDAQ Software - Manual (Page 63)

Section 5. Program Creation and Editing
Below is an example of the Parameter dialog box for the differential voltage
instruction (VoltDiff).
The Prev (Previous) and Next buttons can be used to move to the next (or
previous) instruction with the parameter entry box opened.
Short Cuts for Editing the Parameters
Right-clicking or pressing F2 on a parameter that uses a variable as an input
type will display a list of variables that have been defined in the program. A
sample list is shown below.
The variable list is sorted by variable type and then alphabetically by name. In
the list above, the first green A denotes that the variable AIRCOOL is set up as
an Alias.
Constants are listed with a blue C, Dimensioned variables are listed with a red
D, and Public variables are listed with a black P.
At any time you can press F10 to bring up the list of variables, regardless of
the input type for the selected parameter. Also, defined variables can be
selected from the Variables drop-down list box at the upper right of the
Parameter dialog box.
5-3