SkyTrak 6036 Service Manual - Manual (Page 144)

Section 8B Cummins Engine
8B-24 Model 6036/6036T S/N 9B0500 thru 14833
17. Disconnect transmission drive shaft from the
transmission:
(a) Remove the U-bolt assembly or bearing
straps, Fig. 6.1, attaching the drive shaft
cross assembly to the drop box input shaft
yoke. Slide slip joint towards transmission
so cross slips out of drop box input shaft
yoke.
NOTE: Wrap tape around bearings and cross so
bearings don’t drop off cross.
(b) Remove the cap and bolt assembly or
bearing straps securing the drive shaft
cross assembly to the transmission output
shaft yoke.
NOTE: Wrap tape around bearings and cross so
bearings don’t drop off cross.
(d) Remove drive shaft assembly from forklift.
18. Detach and remove the hydraulic lines from
the main pump.
IMPORTANT: Be sure main suction line is raised
above level in reservoir.
19. Detach and remove the transmission cooler
lines at the transmission.
20. Remove the engine and transmission from the
forklift frame as follows:
(a) Attach a suitable engine hoist to the lift
plates, Fig. 8B.45, on the top of the
engine.
(b) Remove both transmission mounts from
the transmission and frame.
(c) Remove the capscrew, vibration mount,
rebound washer, and locknut attaching the
engine mount to the frame.
(d) Pull the engine and transmission out the
rear of the forklift.
21. With the engine and transmission adequately
supported, separate the engine from the
transmission as follows:
(a) Remove one of the two access hole
plastic plugs on the engine flywheel
housing.
(b) Remove the eight torque converter drive
plate screws and washers.
(c) Remove the eleven capscrews securing
the converter housing to the flywheel
housing.
(d) Using a suitable engine hoist, separate the
transmission from the engine.
8B.14 HOW TO OVERHAUL
THE ENGINE
Refer to the Cummins Shop Manual, B Series
Engines.
8B.15 HOW TO INSTALL THE
ENGINE IN FORKLIFT
1. Install two 2.5" (63,5 mm) guide studs in the
engine housing as shown in Fig. 8B.47.
2. Rotate the engine flywheel to align a drive
plate mounting screw hole with the flywheel
housing access hole.
3. Install a 4.0" (101,6 mm) long locating stud
(0.375-24 fine thread) in a drive plate nut as
shown in Fig. 8B.48.
4. Rotate the drive plate to align the locating stud
with the flywheel drive plate mounting screw
hole positioned in step 2.
5. Position the transmission on the flywheel
housing with the guide and locating studs
aligned.
6. Install the nine capscrews securing the
converter housing to the flywheel housing.
MA2030
Fig. 8B.45 Engine Lifting Plates