SkyTrak 6036 Service Manual User Manual
Page 87
Section 7
Transmission
Model 6036/6036T S/N 9B0500 thru 14833
7-1
7.1
TRANSMISSION PREVENTIVE
MAINTENANCE .................................. 7-1
7.1.1
Daily or 10 Hour Intervals ......................... 7-1
7.1.2
First 50 Hours and 500 Hour Intervals
Thereafter .................................................. 7-1
7.1.3
1000 Hour Intervals ................................... 7-2
7.2
HOW TO TOW THE FORKLIFT .......... 7-2
7.3
HOW TO DRAIN TRANSMISSION ..... 7-3
7.4
HOW TO BACK FLUSH
OIL COOLER ...................................... 7-3
7.5
TRANSMISSION REMOVAL .............. 7-3
7.6
TRANSMISSION REPLACEMENT ..... 7-3
7.7
INTERNAL SERVICING ...................... 7-3
7.8
INSTALLATION .................................. 7-3
7.9
TROUBLESHOOTING ........................ 7-4
7.10
SPECIFICATIONS .............................. 7-5
• To avoid severe burns, DO NOT attempt this
procedure when the engine, cooling, and hy-
draulic systems are hot. Wait until they have
cooled before proceeding.
• Care must be exercised to avoid skin rashes,
fire hazards and inhalation of vapors when
using solvent and alkali cleaners.
• Be careful when using steam cleaner to
avoid burns.
IMPORTANT: These instructions cover only the
routine maintenance of the transmission. Refer to
your 18000 Powershift Transmission Maintenance
and Service Manual for transmission diagnosis,
repair and component replacement. Cleanliness
is of extreme importance. Before attempting any
repairs, the exterior of the unit must be cleaned to
prevent the possibility of dirt from entering the
mechanism.
Fig. 7.1 Transmission Cover Access Hole
3.
Remove the transmission dipstick through
the access hole in the transmission cover,
Fig. 7.1, and check the reading.
4.
Add oil (see table on page 7-2) to the trans-
mission as required to being it up to the full
mark. Transmission capacity is 4.3 gallons
(16,3 liter).
7.1.2 First 50 Hours and 500 Hour
Intervals Thereafter
Filter Change
1.
Level the forklift, ground the carriage, shut
off the engine, and engage the parking lock.
2.
Remove the transmission cover from the top
of the frame.
3.
Place a receptacle under the transmission
filter, Fig. 7.2, to catch fluid when the filter is
removed.
4.
Remove the old filter element and discard
the element.
5.
Apply a thin film of clean oil to the new ele-
ment gasket.
CONTENTS
Par.
Title
Page
SECTION 7
TRANSMISSION, CLARK SERIES 18000
7.1.1 Daily or 10 Hour Intervals
Level Check
1.
Check the oil level with the engine running
at idle, and oil at normal operating tempera-
ture.
2.
Level the forklift, engage the parking lock,
ground the carriage, and place the travel se-
lect lever in neutral.
ACCESS HOLE IN
TRANSMISSION COVER
COVER MOUNTING
NUTS (5)
Warning
OA0392
7.1
TRANSMISSION
PREVENTIVE
MAINTENANCE