14 troubleshooting contents – SkyTrak 6036 Service Manual User Manual

Page 318

Advertising
background image

Section 10.

Electrical System

10-56

Model 6036/6036T S/N 9B0500 thru 14833

5.

Replace coolant in engine and heater lines,
connect the ground cable (2, Fig. 10.16) to the
negative terminals of the batteries, start the
engine, allow engine to idle for several min-
utes, and check for leakage at the heater
connections.

6.

Disconnect battery ground cable (2, Fig.
10.16) from the negative terminals of the
batteries.

7.

Connect wiring to motor.

8.

Prepare to electrically ground the heater unit
by positioning tooth type ground washers (3,
Fig 10.42) over the tapped holes in the coolant
inlet/outlet side of the heater. Use a thin,
transparent tape to temporarily secure the
washers to the heater unit.

9.

Slide heater and fan unit (7) into position
under suspension support (12) without disturb-
ing the ground washers (3) which were taped
into position during the previous step.

10. Install two lock washers (5), capscrews (4)

and spacers (6) at the other side of the
suspension support (12).

11. Install two lock washers (2) and capscrews (1)

through the holes in the suspension support
(12) and through the tooth type grounding
washers (3) into the tapped holes in the
heater.

12. Connect negative (–) cable (2, Fig. 10.16) to

the batteries.

13. Test heater fan motor operation.

10.14 TROUBLESHOOTING

CONTENTS

Title

Page

WARNING DEVICES

10-57

Horn, Backup Alarm, Reverse Switch and
Warning Lights

10-57

CIRCUIT BREAKERS/FUSES

10-58

STARTING SYSTEM

10-59

Starter, Starting Motor Relay and
Thermo Start Plug

10-59

CHARGING SYSTEM

10-62

Alternator and Batteries

10-62

SWITCHES AND SOLENOIDS

10-63

Ignition and Neutral Start Switches

10-63

Fuel Run Solenoid

10-64

Park Lock Switch

10-64

Reverse Switch and Backup Alarm

10-65

Steering Select Switch and Solenoid

10-65

GAUGES AND INDICATOR LIGHTS

10-65

Hourmeter

10-65

Warning Lights

10-66

Engine Low Oil Pressure Switch

10-66

Engine Coolant High Temperature Switch

10-67

Alternator Warning Light

10-67

Transmission High Oil Temperature Switch

10-67

Fuel Level Gauge

10-68

OPTIONAL LIGHT CIRCUIT

10-68

Directional and Emergency Flasher Switch

10-68

Momentary Brake Light and Switch

10-69

Headlight and Rear Work Light Switch

10-69

WINDSHIELD WASHER/WIPER

10-70

AIR CIRCULATION FAN

10-73

CAB HEATER

10-73

Advertising