SkyTrak 6036 Service Manual - Manual (Page 85)

Section 6 Drive Shafts and Drop Box
Model 6036/6036T S/N 9B0500 thru 14833 6-7
6.3.8 Installation of Drop Gear Box
1. From above and below the frame, secure the
drop gear box to the frame with four capscrews
and lock washers. Torque capscrews 67.5 to
82.5 lb-ft (91,8 to 112,2 Nm).
2. Remove the level plug, Fig. 6.2.
3. Using level plug opening, fill housing with
tractor hydraulic fluid meeting specifications in
paragraph 6.3 until it flows from the level plug,
Fig. 6.2.
4. Install the level plug securely.
5. Secure drive shaft cross assembly to drop box
input shaft yoke with a U-bolt assembly or
bearing strap, Fig. 6.1. Torque U-bolt assem-
bly to 20 to 24 lb-ft (27 to 37 Nm) or the bearing
strap to 55 to 60 lb-ft (75 to 82 Nm).
6. Secure the drive shaft cross assemblies to the
drop box output shaft yokes with a U-bolt
assembly, Fig. 6.1. Torque U-bolt assembly to
20 to 24 lb-ft (27 to 37 Nm).
7. Install transmission and hydraulic tank covers
on frame.
6.4 SPECIFICATIONS
Transmission and Drop Box–Use a Tractor
Hydraulic Fluid which meets the requirements of
any of the following specifications:
John Deere J20 A
Detroit Diesel C-3; C-2
Ford Tractor M2C134B
White Farm UTHF Q1766, Q1722
Products known to meet these requirements
include:
Texaco THD Oil
ARCO Tractor Fluid or equivalent
CAPACITIES:
Drop Box: 2.0 quarts (1,9 liter)
Transmission System (including filter and oil
cooler): 3 gallons (13,7 liter)
Transmission Filter: 1 quart (0,95 liter)
6.3.7 Assembly of Drop Gear Box
for S/N 9N0942 and After Only
1. If necessary, install dowels (16).
2. Press in matching bearing cups (8) and press
on cones (9).
3. Place gears (5, 6, and 7) in housing and align
the holes in the housing with the dowel pins.
4. Install and loosely tighten capscrews (15), lock
washers (13) and nuts (11).