SkyTrak 6036 Service Manual - Manual (Page 21)

Section 3 Boom
3-3 6036/6036T S/N 9B0500 thru 14833
CAPSCREW ENDS TO BE FLUSH
TO 0.19" (5 mm) RECESSED IN
WEAR PAD INSERT
INTERMEDIATE
BOOM
CAPSCREW ENDS TO BE FLUSH
TO 0.19" (5 mm) RECESSED IN
WEAR PAD INSERT
INNER BOOM
PAD, INSERT (1),
LOCK WASHER (2),
FLAT WASHER (2),
3/8-16 X 7/8"
CAPSCREW (2)
BASE END PIN
EXTEND/RETRACT
CYLINDER
OUTER BOOM
3. Working from the rear boom cover opening,
record the number of shims beneath each wear
pad as you remove the side and top wear pads
from intermediate boom, Fig. 3.6.
Fig. 3.3 Rear Wear Pads Attached to Inner Boom
GAP MUST BE 0.07 TO
0.13" (1,8 TO 3,3 mm)
GAP MUST BE 0.07 TO
0.13" (1,8 TO 3,3 mm)
ANTI-BUCKLE BAR
INTERMEDIATE
BOOM
ROD END PIN
PAD, #14 GA SHIM, INSERT (2),
LOCK WASHER (4),
FLAT WASHER (4),
3/8-16 X 3/4"
CAPSCREW (4)
MA0031
MA0041
PAD, SPACER, INSERT (2),
LOCK WASHER (6),
FLAT WASHER (6),
3/8-16 X 1-3/4"
CAPSCREW (6),
14 GA SHIM
Fig. 3.4 Extend/Retract Cylinder
12. Adjust hose tension as described in para-
graphs 3.1.9.
13. Check and adjust chain tension as described
in paragraphs 3.1.6 and 3.1.7.
14. Refer to Fig. 3.1 and install the rear boom
cover.
3.1.2 Intermediate Boom Replacement
a Removal
1. Refer to paragraph 3.1.1.a and remove the
inner boom.
2. Remove the rod end pin, Fig. 3.4, and re-
taining rings that attach the rod end of the
boom extend/retract cylinder to the interme-
diate boom. Lower the rod end to the anti-
buckle bar.