SkyTrak 6036 Service Manual - Manual (Page 89)

Section 7 Transmission
Model 6036/6036T S/N 9B0500 thru 14833 7-3
1
2
5
3
6
4
4. Flat Washer
5. Oil Cooler Support
6. Rear Support
Fig. 7.4 Transmission Oil Cooler
1. Lock Nut
2. Transmission Oil Cooler
3. Capscrew, hex hd
MA0321
7.3 HOW TO DRAIN
TRANSMISSION
The procedure for draining the transmission is de-
scribed in paragraph 7.1.3.
7.4 HOW TO BACK FLUSH
OIL COOLER
The transmission oil cooler, Fig. 7.4, is mounted
behind the radiator. Periodically disconnect and
back flush the oil cooler with oil and compressed
air until all foreign material has been removed. If
necessary, remove oil cooler from forklift and
clean it using oil, compressed air and steam.
IMPORTANT: DO NOT use flushing compounds
for cleaning purposes.
7.5 TRANSMISSION REMOVAL
Please refer to paragraph 8.6 for engine and
transmission removal instructions (they are re-
moved as a single unit).
7.6 TRANSMISSION
REPLACEMENT
If the transmission is to be replaced as a complete
assembly, detach and transfer the following:
• Tandem Pump
• Transmission Temperature Switch
• Transmission Connector Kit (from valve)
• Two Side Mount Brackets
(Neutral Start Switch comes with new
transmission)
7.7 INTERNAL SERVICING
If servicing the transmission internally, the tandem
pump may require removal for disassembly.
Refer to the enclosed "Clark 18000 Powershift
Transmission Maintenance and Service Manual"
when servicing the transmission internally.
7.8 INSTALLATION
Please refer to paragraph 8.8 for engine and
transmission installation instructions (they are in-
stalled as a single unit).