SkyTrak 6036 Service Manual - Manual (Page 233)

Section 9 Hydraulic System
Model 6036/6036T S/N 9B0500 thru 14833 9-83
2. Remove piston (3), shim or shims (4), and
springs (5 and 6) from housing bore.
3. Carefully remove O-ring (7) to avoid scratch-
ing the housing bore.
4. Carefully remove retaining ring (8) to avoid
scratching housing bore.
5. Remove washer (9), plunger (10) and spring
(12) from housing bore.
6. Remove cup (11) from plunger (10).
7. Remove plug (23) from housing (13).
8. Remove O-ring (22), cup (20) and back-up
ring (21) from plug (23).
9. Remove washer (19), sleeve (18), spring (17)
and guide (16) from the housing bore.
NOTE: Some valves may not have a sleeve (18).
10. Remove valve and ball assembly (15) from
housing bore.
11. Remove O-ring (14) from the valve and ball
assembly.
c. Cleaning and Drying
Clean all metal parts in an approved cleaning
solvent such as trichlorethylene and blow dry.
d. Inspection, Repair and Replacement
1. Inspect valve bore for deep grooves or other
damage. If there is any damage to the bore,
replace the entire brake valve.
2. Remove small scratches in the bore using
emery cloth of very fine grit. Use the emery
cloth with a rotary motion.
1. Retaining Ring
2. Boot
3. Piston
4. Shims (as required)
5. Spring
6. Spring
7. O-ring
8. Retaining Ring
9. Washer
10. Plunger
11. Cup
12. Spring
13. Housing
14. O-ring
15. Valve and Ball Assembly
16. Guide
17. Spring
18. Sleeve
19. Washer
20. Cup
21. Backup Ring
22. O-ring
23. Plug
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18
19
20
21
22
23
MA0701
Fig. 9.50 Brake Valve Exploded View
17