SkyTrak 6036 Service Manual - Manual (Page 88)

Section 7 Transmission
7-2 Model 6036/6036T S/N 9B0500 thru 14833
TRANSMISSION FILTER
TRANSMISSION
DIPSTICK
Fig. 7.2 Transmission Filter and Dipstick
6. Turn the element on the transmission fitting.
Tighten the element to 20 to 25 lb-ft (27 to 34
Nm).
7. Remove the receptacle.
8. Check the transmission level as instructed in
the previous paragraph and add tractor hy-
draulic fluid as required.
9. Install the transmission cover on the frame.
7.1.3 1000 Hour Intervals
Fluid Change
1. Level the forklift, ground the carriage, shut off
the engine, and engage the parking lock.
2. Place a funnel with a flexible drain and a re-
ceptacle under the transmission sump hous-
ing.
Fig. 7.3 Transmission Sump Plug and Screen
ENGINE
FLYWHEEL
MOUNTING
FLANGE
PLUG AND
SCREEN
GASKET
TRANSMISSION
OA0402
OA0412
3. Remove sump plug and screen with gasket
from housing, Fig. 7.3. Allow the transmission
to drain completely.
4. Clean the plug and screen thoroughly with an
approved solvent.
5. Install a new filter element as described in
paragraph 7.1.2. DO NOT START ENGINE.
6. Install the cleaned drain plug and screen and
gasket into the transmission sump housing.
7. Add oil (see table on this page) as required to
bring level up to full mark. Transmission ca-
pacity is 4.3 gallons (16,3 liter).
MIL-L-2104C
10W Motor Oil*
Castrol Deusol CRD
Esso Essolube D-3HP
Esso Essolube XD-3
Castrol Agricastrol HDD
Shell Rimula CT
Shell Rimula X
Shell Rimula TX
* 5W20 Motor Oil may be substituted
for -30° F to 70° F (-34 to 21° C) only.
7.2 HOW TO TOW
THE FORKLIFT
Before you tow the forklift for long distances be
sure to disconnect and remove both front and rear
drive lines to avoid damage to the transmission.
Because of the design of the hydraulic system, the
engine cannot be started by pushing or towing.
For short distance towing consult your Owners/
Operators Manual.