SkyTrak 6036 Service Manual - Manual (Page 321)

Section 10. Electrical System
10-59 Model 6036/6036T S/N 9B0500 thru 14833
1. Battery is discharged.
2. Defective starting motor
connections or loose
battery connections.
3. Starting motor faulty.
4. Relay or solenoid contacts
are burned.
5. Engine is seized;
crankshaft cannot rotate.
1. Battery is discharged.
2. Ignition switch, relay or
solenoid inoperative.
3. Starting circuit is open or
has high resistance.
Trouble Probable Cause Remedy Reference
Starting System—GENERAL
Engine will not
crank and starting
motor relay or
solenoid does not
engage. Check battery and charge or
replace battery.
Check circuitry and repair or
renew faulty components.
Check circuit connections and
repair or renew faulty wiring.
See para. 10.6.2
See para. 10.7.1
See para. 10.5.1
Starter relay
closes and
solenoid engages
but engine will not
crank. Check battery and charge or
renew.
Check, clean and tighten
connections.
Inspect, repair or renew.
Renew relay or solenoid.
Repair or replace engine and
transmission as required.
See para. 10.6.2
See para. 10.5.1
and 10.6.2
See para. 10.5.2
See para. 10.5.2
and 10.5.4
Section 8
1. Defective starting motor
drive assembly.
2. Defective solenoid or
pinion engagement levers.
3. Defective flywheel ring
gear.
Starting motor
turns but does not
crank engine. Inspect and repair or renew.
Inspect and repair or renew.
Inspect and renew.
See para. 10.5.2
See para. 10.5.2
See para. 10.5.2
1. Discharged battery.
2. Excessive resistance in
starting circuit.
3. Defective starting motor.
4. Excessively tight engine.
Engine cranks
slowly. Check battery and charge or
renew.
Check circuit connections and
repair or renew faulty wiring.
Inspect and repair or renew.
Investigate cause and repair
or replace engine.
See para. 10.6.2
See para. 10.5.2
Section 8
1. Fuel tank is empty.
2. Engine is malfunctioning.
Engine turns over
but fails to start. Fill fuel tank.
Contact authorized engine
dealer.
See para. 8.4.2
See para. 8.7