SkyTrak 6036 Service Manual - Manual (Page 82)

Section 6 Drive Shafts and Drop Box
6-4 Model 6036/6036T S/N 9B0500 thru 14833
END YOKE
OIL SEAL
END YOKE
DROP BOX
INSPECTION
COVER
SCREW &
WASHER
SCREW &
WASHER
LOCK WASHER
CAPSCREW
FRAME
SCREW &
WASHER
OIL SEAL
LEVEL PLUG
(on late
models)
LEVEL PLUG
(on early
models)
END YOKE
OIL SEAL
DROP BOX
ASSEMBLY
VENT/FILL
PLUG
6.2.2 Oil Seals
a. Inspection
Replace oil seal, Fig. 6.2, if worn or damaged.
b. Removal
To remove oil seal, remove screw, Fig. 6.2,
washer, end yoke and oil seal.
c. Installation
1. To install oil seal, press oil seal and yoke on
shaft.
2. Press yoke, Fig. 6.2, on shaft and secure with
washer and screw.
DRAIN
PLUG
PA0261
Fig. 6.2 Exploded View of Drop Gear Box for S/N 9N0941 and Before
6.2.3 Internal Inspection and Servicing
NOTE: JLG does not recommend servicing of
gears, shafts or bearings inside this drop box.
Attempts at internal disassembly of these items
may cause damage to other parts and possibly the
drop box case. The only serviceable items of this
drop box are the yokes and oil seals. If internal
servicing of drop box is required while still under
warranty, return it to JLG for replacement with a
new drop box.
6.2.4 Removal and Installation
Refer to paragraph 6.3.3 for removal instructions
and paragraph 6.3.8 for installation instructions.