Dbw tuning – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 114
108
© 2014 AEM Performance Electronics
Infinity User Manual
TPS Min Volts:
This should be set to the manufacturer specifications.
TPS Max Volts must be > TPS Min Volts.
User entries that do not meet this criteria are not allowed.
Min value = 0, Max value = 5
Fuel Pressure Max Volts:
This should be set to the manufacturer specifications.
TPS Max Volts must be > TPS Min Volts
User entries that do not meet this criteria are not allowed.
Min value = 0, Max value = 5
DBW Tuning
Note: Data will not be shown here if "Drive-by-Wire 1 User Enable" is disabled. Enable
"Drive-by-Wire 1 User Enable" to view the following DBW Tuning settings.
Drive by Wire Setup...:
Selecting this box will open the DBW wizard for configuring throttle bodies.
Drive-by-Wire 1 User Enable:
Enable or disable DBW 1.
Drive-by-Wire 2 User Enable:
Enable or disable DBW 2
DBW Idle Control: