Flash memory functions – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 16
10
© 2014 AEM Performance Electronics
Infinity User Manual
While running the Infinity Tuner Wizard Installer it is unable to successfully finish. A
message reads “Setup Infinity Tuner Wizard needs the Microsoft .NET 4.0 Full
Framework to be installed. Press OK and Install that first.” What should I do?
You need to install Microsoft .NET Framework 4. These files can be found at:
The installer “dotNetFx40_Full_setup.exe” is available for download on this site. Once you
have installed Microsoft .NET Framework 4 you may continue using Infinity Tuner or installing
the Infinity Tuner Wizard.
When I first start Infinity Tuner I am experiencing the following error message: “The
wizard plug in has encountered an unknown problem(UI thread). Please try again.”
What should I do?
You need to install Microsoft .NET Framework 4. These files can be found at:
The installer “dotNetFx40_Full_setup.exe” is available for download on this site. Once you
have installed Microsoft .NET Framework 4 you may continue using Infinity Tuner or installing
the Infinity Tuner Wizard.
Flash Memory Functions
Changes made to calibration tables are stored on the ECU in a temporary memory location and
applied immediately. In other words, while tuning live, all changes take effect immediately. They
are not however immediately saved to ECUs flash memory. The menu function Target – Commit
modifications (Hot Key – CTRL + SHIFT + C) is used to save all current changes to the flash.
This feature allows the user to choose what changes to save to the ECU during a tuning session.
Target – Revert modifications (Hot Key – CTRL + SHIFT + R) removes any changes not
previously saved. At key off, the system will automatically commit all unsaved changes if the Key
Off Commit option is checked in the Tuning Preferences Setup Wizard page.