AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual - Manual (Page 225)

Tuning Guide 219
© 2014 AEM Performance Electronics
Traction Control
With individual wheel speed sensors installed, the ECU can measure front vs rear speeds and
limit engine power to prevent excessive wheel slip. Desired wheel slip depends on the calculated
gear position and a driver-adjustable trim knob or switch.
Wheel Speed Input Setup
Non-Driven Wheel Speed Calibration Factor
Units: Frequency to MPH
Description: This calibrates the speed of the wheel that is not attached to the differential. This
would be a rear wheel on FWD vehicles and a front wheel on RWD vehicles.