Drivewheelspeed (right) input, Groundspeed (left) input – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 188
182
© 2014 AEM Performance Electronics
Infinity User Manual
Driven Wheel Speed Calibration:
This is a multiplier which is used to synchronize the actual speed of the vehicle to the Infinity
Tuner's Driven Wheel Speed on left side.
Min value = 0, Max value = 10
Note this channel must be set to 1.00 if CAN wheelspeeds are used.
Driven Wheel Speed Smoothing:
Value used to smooth signal.
Min value = 0%, Max value = 99.9%
Driven Wheel Speed Calibration:
This is a multiplier which is used to synchronize the actual speed of the vehicle to the Infinity
Tuner's Driven Wheel Speed on right side.
Min value = 0, Max value = 10
Note this channel must be set to 1.00 if CAN wheelspeeds are used.
Driven Wheel Speed Smoothing:
Value used to smooth signal.
Min value = 0%, Max value = 99.9%